13.1.9. Removal and installation of the lever of a screen wiper of a windshield



1. Moisten a windshield with water.
2. Start for a short time a screen wiper and switch off it the switch. Brushes have to will stop in extreme situation.
3. Mark the provision of a brush at correctly adjusted levers on glass, for example, with an adhesive tape.
4. Open a cowl.

5. Turn off a nut (1) approximately on 2 turns, but do not turn off it. Slightly move the left lever (2) in different directions so that it descended from an axis. Completely turn off a nut and remove the lever from an axis.

If the lever separates hard, bring under it a wrench and carefully remove the lever. For this purpose it is possible to use also special tool to removal, for example, of HAZET 1966-05.

6. Turn off 2 nuts (3) and remove the right lever.



1. Make sure that the electric motor of a screen wiper is in extreme situation. If necessary start the electric motor for a short time and stop the switch.
2. Install screen wiper levers on an axis and expose on the marks put with an adhesive tape at removal.
3. Screw nuts and tighten them by hand.
4. Double-check extreme position of levers. For this purpose close a cowl, moisten glass with water and for a short time start a screen wiper. Levers have to return to the established situation and should not go beyond glass at purification of glass.
5. If necessary once again turn off nuts and repeat adjustment.
6. Fix nuts by the moment of 20 Nanometers.