3648d64d

13.1.31. Removal and installation of facing of an external rear-view mirror

Removal

 PERFORMANCE ORDER

1. Establish an external mirror inside.
2. Disconnect a negative cable (-) of the rechargeable battery at the switched-off ignition. It is previously necessary to remove a box of the filter of air of salon. Before a detachment of a cable find out a protective code of the radio receiver if that is available, address the Section Replacement of the Rechargeable Battery.

3. Press a mirror inside. To record a mirror in this situation insert wooden whetstone (1) about 10 cm long and clamp it. (2) – facing of an external mirror.

At models with the electric drive of a mirror cast away a mirror inside.

4. By means of the screw-driver (1) release a lock spring (2), at the same time pull facing of a mirror outside a little and release it. You watch that at the same time wooden whetstone was not squeezed out.

On an illustration the mirror with the removed facing is shown.

5. Take out wooden whetstone and cast away a mirror forward. Completely separate facing from the holder of a mirror (3). At the same time it is necessary to disunite the socket (4) indexes of turn.


Installation

 PERFORMANCE ORDER

1. Insert facing over the holder of a mirror and record it.
2. Press a mirror forward and back and check correctness of installation of facing.
3. Attach a negative cable (-) to the rechargeable battery at the switched-off ignition. Establish into place a box of the filter of air of salon. Enter a code of the radio receiver and determine time on hours.
4. Check work of the index of turn.