Check gaps in interface of a door of a back to adjacent elements of a body. Values are given in Specifications.

1. Open a back door.

2. Turn out bolts of fastening (1) on the right and left loops.

3. Remove a cap of a cargo compartment, address appropriate section.
4. Turn off bolts of fastening of a clamp.
5. Turn off bolts of fastening of a side plastic emphasis. Wring out an emphasis forward.
6. Close a door of a back and adjust a gap. Fix bolts of loops and a clamp by the moment of 9 Nanometers.
7. Adjust an emphasis so that they adjoined at the closed door. Tighten fastening bolts.
8. Establish into place a cap of a cargo compartment, address appropriate section.

Check gaps in interface of a door of a back to adjacent elements of a body. Values are given in Specifications.

1. Open a back door.
2. Disconnect by means of a plastic wedge facing of a roof in a back part of salon and pull a little back. Carefully insert wooden whetstone 65 mm high between a roof and facing.
3. Turn off 2 nuts of fastening of a loop between a roof and facing.
4. Take out a clip and remove internal facing in a luggage carrier.
5. Turn off bolts of fastening of a clamp.
6. Close a door of a back and adjust a gap. Tighten bolts and nuts of fastening on loops the moment of 9 Nanometers.
7. Establish internal facing in a luggage carrier and fix facing of a roof.