3648d64d

13.1.18. Removal and installation of a bumper

Removal

 PERFORMANCE ORDER

1. Mark with paint the provision of the corresponding forward wheel concerning a nave. It will allow to establish at assembly the balanced wheel in its former situation. Weaken bolts of fastening of a wheel before a car poddomkrachivaniye. Lift a forward part of the car, put it on supports and remove a forward wheel.
2. Lift a forward part of the car and establish on supports.

Lifting operation and installations of the car on supports is connected with danger! Therefore before carrying out operation study Poddomkrachivaniye's Section and towage of Introduction to the management.

3. Remove a forward loker, address appropriate section.

4. Turn out the lock screw (1) between a wing and a bumper. (4) – adjusting screw.

5. Disconnect by means of the screw-driver (2) a bracket (3) from a bumper and incline it to the center of the car.
6. Pull a bracket back and remove from a bumper.
7. Remove the sensor of temperature of external air, address the Section Removal and installation of the sensor of temperature of external air.
8. Disunite the socket of the left and right fog lights.
9. Disunite the socket of the assistant to the parking if it is established.

10. Turn out 2 screws of fastening (2) at fog lights on the right and at the left.

11. Open a cowl and turn out 2 screws (1) at headlights on the right and at the left.
12. Remove by means of the assistant a bumper from the car.


Installation

 PERFORMANCE ORDER

1. Establish by means of the assistant a bumper into place.
2. If it is necessary, adjust a gap by means of the screw (4). Value of a gap is given in Specifications.
3. Fix a bumper by 4 screws the moment of 4 Nanometers.
4. Insert a bracket between a wing and a bumper so that the collar of a bracket entered a guide on a bumper. Screw the lock screw.
5. Install the sensor of temperature of external air, address the Section Removal and installation of the sensor of temperature of external air.
6. Join the socket of foggy lamps.
7. Join the socket of the assistant to the parking if it is available.
8. Establish a loker of a wing, address the Section Removal and installation of a forward loker covered.
9. Establish into place a forward wheel so that the marks put at removal coincided. Previously grease with a thin layer of bearing lubricant the aligning wheel disk belt on a nave. Do not grease bolts of fastening of a wheel. Replace rusty bolts. Wrap bolts. Lower the car on wheels and tighten bolts cross-wise the moment of 110 Nanometers.
10. Attach a negative cable (-) to the rechargeable battery at the switched-off ignition. Establish into place a box of the filter of air of salon. Enter a code of the radio receiver and determine time on hours.
11. As soon as possible check adjustment of headlights for HUNDRED and, if necessary, adjust.