3648d64d

13.1.20. Removal and installation of a forward wing

Removal

 PERFORMANCE ORDER

1. Mark with paint the provision of the corresponding forward wheel concerning a nave. It will allow to establish at assembly the balanced wheel in its former situation. Weaken bolts of fastening of a wheel before a car poddomkrachivaniye. Lift a forward part of the car, put it on supports and remove a forward wheel.

Lifting operation and installations of the car on supports is connected with danger! Therefore before carrying out operation study Poddomkrachivaniye's Section and towage of Introduction to the management.

2. Remove a forward loker of a wing, address appropriate section.
3. Turn out a lock bolt between a wing and a bumper, disconnect and remove a bracket as it is described in the Section Removal and installation of a bumper.
4. Turn out bolts of fastening and remove an expansion clip of a cover of the bottom, and also facing of a longitudinal beam around a wing.
5. Disconnect by means of a plastic wedge an entrance level of doors from the holder of a clip and remove.

6. Enter a plastic wedge into a gap between a wing (1) and facing of a longitudinal beam (2) and take out facing from two holders of clips (the shooter on an illustration).

7. Turn off 2 nuts (3) fastenings of a wing.
8. Open a cowl and establish it vertically.

9. Turn out bolts (1) and remove a wing (2).

10. Disconnect a cover (3) and the sealing film (4).


Installation

 PERFORMANCE ORDER

1. Installation is carried out in the sequence, the return to removal.
At the same time you watch correctness of closing of a cowl, and also a gap in relation to a forward door and a cowl. Value of a gap is given in Specifications.
2. Establish into place a forward wheel so that the marks put at removal coincided. Previously grease with a thin layer of bearing lubricant the aligning wheel disk belt on a nave. Do not grease bolts of fastening of a wheel. Replace rusty bolts. Wrap bolts. Lower the car on wheels and tighten bolts cross-wise the moment of 110 Nanometers.