1. Disconnect a negative cable (-) of the rechargeable battery at the switched-off ignition. It is previously necessary to remove a box of the filter of air of salon.

Before a detachment of a cable find out a protective code of the radio receiver if that is available, address the Section Replacement of the Rechargeable Battery.

2. Completely lower glass and open a door.
3. Separate by means of a plastic wedge an entrance level of a door from the holder of a clip and remove.
4. Remove the lower fringing on a rack And.
5. Take out a cover from facing in the bottom of a rack And around legs and turn out the bolt lying under it.
6. Separate by means of a plastic wedge facing in the bottom of a rack And from holders of a clip and remove. Under it there are electric wires of a door.
7. Disunite sockets of electric wires.

8. Take out by means of a plastic wedge a cover for a cable (1) from a rack And yes extend wires.

9. Turn out fastening bolts (2) stoppers of a door.
10. Ask the assistant to take a door. Turn out nuts (3) fastenings of a loop below and above. Remove a door and put it on a soft lining.

1. By means of the assistant establish into place a door and screw nuts of fastening of loops, without tightening them.
2. Close a door and check a gap. If necessary adjust a door, address appropriate section.
3. Tighten nuts of fastening of loops the moment of 8 Nanometers.
4. Fix a door stopper by the moment of 10 Nanometers.
5. Further installation is carried out in the sequence, the return to removal.
6. Attach a negative cable (-) to the rechargeable battery at the switched-off ignition. Establish into place a box of the filter of air of salon. Enter a code of the radio receiver and determine time on hours.