1. Grease a pusher and basic necks of camshafts with pure motive oil. Check ease of the course of pushers. 2. Install camshafts of inlet and final valves and expose them on the axial bearing. At the same time pay attention to an arrangement of shaft. Marking of shaft is put in a point of contact with the persistent bearing.
01 Camshaft of inlet valves 00 Camshaft of final valves.
|
3. Install camshafts so that openings (3) were in asterisks of camshafts against each other and markings of the camshaft and a cover of the bearing coincided.
|
Camshafts are very sensitive to retension and can collapse. Therefore you watch that installation did not lead to any overloads of shaft. |
|
4. Turn a bent shaft in the opposite direction to position of the piston of the first cylinder 30 ° before VMT.
|
5. Establish covers of bearings according to their marking.
|
Covers of bearings are asymmetric. You watch that they were not displaced. |
|
6. Engine 611: Fix covers of bearings of camshafts as follows:
· Tighten bolts of fastening of covers of E2, E4; and A2, A4 in stages, every time on one turn. Tighten covers the moment of 9 Nanometers. You watch that at an inhaling of bolts camshafts did not warp. · Wrap covers of E1, E2, E5 bearings, and also A1, A3, A5 the moment of 9 Nanometers. 7. Engine 612: Fix covers of bearings of camshafts as follows: · Tighten bolts of fastening of covers of E2, E5; and A2, A5 in stages, every time on one turn. Tighten covers the moment of 9 Nanometers. You watch that at an inhaling of bolts camshafts did not warp. · Wrap covers of E1, E3, E4, E6 bearings and also A1, A3, A4, A6 the moment of 9 Nanometers. 8. Install the piston of the first cylinder in the provision of VMT. 9. Fix the camshaft of inlet valves. For this purpose implant a lock finger through a cover of the first bearing into an opening in an asterisk of a shaft of inlet valves. 10. Install an asterisk with a chain on the camshaft of inlet valves, at the same time pay attention to the directing pin. 11. Fix an asterisk by new bolts the moment of 18 Nanometers. If necessary cut off and remove a cable connector. 12. Establish the top guide, address appropriate section. 13. Establish a natyazhitel of a chain with a new sealing ring, address appropriate section. 17. Establish the top covers of the engine, address appropriate section. |