3648d64d

14:17. Removal and installation of the sensor of a rain

The sensor of a rain is fixed on a windshield, at height of a rear-view mirror. It operates intervals of inclusion of a screen wiper.


It is necessary to establish it with extra care not to damage a windshield and optics of the sensor.

Removal

 PERFORMANCE ORDER

1. Disconnect a negative cable (-) of the rechargeable battery at the switched-off ignition. It is previously necessary to remove a box of the filter of air of salon.

Before a detachment of a cable find out a protective code of the radio receiver if that is available, address the Section Replacement of the Rechargeable Battery.


2. Uncover (1).

3. Disunite the socket (2) at the sensor of a rain (4).

4. Put the screw-driver (5) in grooves (3) of the sensor of a rain on each side and open two locks on the right and at the left.
5. Take out the sensor of a rain (4) from the holder.

The lens of the sensor is pasted to a windshield. The lens can be replaced only with HUNDRED.


Installation

 PERFORMANCE ORDER

1. Installation is carried out in the sequence, the return to removal.
2. Attach a cable of mass of the rechargeable battery at the switched-off ignition. Install into place a box of the filter of air of salon. If it is necessary, enter a code of the radio receiver and determine time on hours.
3. Check operation of the sensor of a rain and inclusion of intervals of a screen wiper. For this purpose pour water on a windshield around a sensor arrangement.