1. Uncover the fan or the air filter depending on engine model.
2. Weaken maple a belt. For this purpose establish an external key of Torx of 10 mm and reject the tension lever with a tension roller counterclockwise.

Do not reject the lever for a nut of fastening of a tension roller.

3. Take off maple a belt.
4. Check a belt, address the Head Routine maintenance.

1. Put on maple a belt, since a tension roller. Further put on a belt in the sequence of figures.
2. Slowly turn a tension roller clockwise, at the same time you monitor the provision of a belt on pulleys.
3. The position mark (V) visible from the lower party of the engine, has to be in range (And). If the tag is in other place - does not correspond set length of a belt or the natyazhitel of a belt is incorrectly established.
4. Establish a cover of the fan or the air filter depending on engine model.

1. Remove a compressor belt.
2. Weaken and take off maple a belt also as a compressor belt.

1. Put on maple a belt according to the sequence of figures illustrations and pull also as a compressor belt.
2. Put on a compressor belt.