1. Remove a starter, address appropriate section.
2. Clamp a starter in a clamp. Wrap tightening sponges for protection a rag.

3. Turn off a nut and disconnect a cable from the plug (1) on the traction relay.

4. Turn off nuts (1) and take out the traction relay from the starter block.

1. Grease the interfaced surface of the block of a starter with sealant.
2. Connect the traction relay to the block of a starter and fix.
3. Fix a cable to the plug of the traction relay.
4. Check a starter before installation in the disconnected state.
5. Establish a starter, address appropriate section.