7.4.10. Removal and installation of a starter
The electric motor called by a starter is necessary for start of the internal combustion engine. That the engine of the car started working, it is necessary to untwist it it to speed not less than 300 rpm. It is possible to reach it if the starter reliably works and the rechargeable battery is charged.
As start of the engine requires big electricity consumption, when carrying out maintenance it is necessary to pay attention to reliable connection of cables. The contacts having a rust need to be smoothed out and greased with jellied lubricant.
Removal
|
|
|
1. Disconnect a negative cable (-) of the rechargeable battery at vyklyuchyonny ignition. It is previously necessary to remove a box of the filter of air of salon.
2. Lift and establish a forward part of the car on supports.
|
|
Lifting operation and installations of the car on supports is connected with danger! Therefore before carrying out operation study Poddomkrachivaniye's Section and towage of Introduction to the management. |
3. Uncover the bottom, address the Section Removal and installation of a cover of a motive compartment from the bottom.
4. Engine 112: Remove system of production of the fulfilled gases.
|
|
5. Turn off nuts (1) and disconnect electric wires from a starter. |
6. Turn out 2 screws (2) on a starter.
7. Take aside a cable plait with the holder and take out a starter from a motive compartment down. |
|
