1. Remove the lower cover of a motive compartment, address the Section Check of the Engine by means of the vacuum gage.
2. Merge motive oil or suck away it, address the Section Replacement of Motive Oil and Oil Filter.

3. Disunite the socket (1) of the sensor of level of oil (2).

4. Turn out bolts (3). Incline the sensor and take out it from the case pallet.

1. Install the oil level sensor with a new sealing ring and fix by its moment 14 Nanometers (at the new pallet of a case the moment of 10 Nanometers).
2. Join the socket.
3. Establish the lower cover of a motive compartment, address the Section Check of the Engine by means of the vacuum gage.
4. Fill in motive oil in system, address the Section Replacement of Motive Oil and Oil Filter.
5. Start and warm up the engine. Check the oil level sensor for tightness.

1. Remove the lower part of the pallet of a case.
2. Disconnect from below the oil level sensor (in front, near an oil absorption pipe), having unscrewed 2 Torx screws.
3. Fix the oil level sensor by the moment of 10 Nanometers.