1. Mark with paint the provision of a forward wheel concerning a nave. Thanks to it the balanced wheel can be established easily on the former place. Weaken bolts of fastening of a wheel on the car standing on the earth. Then lift a forward part of the car and remove a forward wheel.
|
2. Screw 1 bolt of fastening of a wheel in a carving opening (2) opposite to the lock screw (1) and tighten by hand. It you will record a brake disk on a wheel nave. |
3. Carefully wring out the screw-driver of a block of a disk brake from a brake disk. 4. Remove a cap of a nave (3) by means of a stripper or the rubber hammer. For this purpose turn a wheel and tap a cap the hammer so that it fell.
|
5. Check a gap in bearings, having strongly pulled and having pressed on a flange. Before each measurement several times turn a nave. |
6. The axial gap in the bearing is measured in auto repair shop by means of the indicator (1) and the holder (2). On the indicator establish 2 mm of a preliminary tightness. The required value of an axial gap: 0.01 - 0.02 mm.
|
In the course of measurement to rotate a nave of a wheel it is not allowed. |
|