1. Carefully enter a depreciation rack through a wheel arch into a support. 2. Establish into place an emphasis and a washer. 3. Tighten the top nut the moment of 60 Nanometers. 4. Fix a depreciation rack to a rotary fist. At the same time insert the top bolt so that the bolt head, looking in the direction of the movement, looked forward. 5. Then tighten at first the top nut (5) the moment of 200 Nanometers, holding a bolt from a provorachivaniye, and then the lower bolt (4) the moment of 110 Nanometers, address an illustration 3.4. 6. Fix a connecting bar on a depreciation rack by the new self-stopped nut and a washer the moment of 40 Nanometers. 7. Fix on a rack of a wire of the sensor of speed and the sensor of wear of a brake shoe. 8. Install into place the windscreen washer liquid tank if he acted, and fix by turn of the lever of a clamp. 9. Establish into place a forward wheel so that the marks put at removal coincided. Previously grease with a thin layer of bearing lubricant the aligning wheel disk belt on a nave. Do not grease bolts of fastening of a wheel. Replace rusty bolts. Wrap bolts. Lower the car on wheels and tighten bolts cross-wise the moment of 110 Nanometers. 10. If the depreciation rack was replaced with new, perform measurement of geometrical parameters of a running gear. |