4.5.3. Removal and installation of a maple belt
Scheme of laying of a maple belt. Engine 112
|
1 — the Bent shaft 2 — the Rejecting roller 1 or the compressor 3 — the Pump of the hydraulic booster 4 — the Rejecting roller 2 |
5 — the Generator 6 — the Pump of cooling liquid 7 — the Tension roller |
Removal
|
1. Weaken a tension of a maple belt. 2. Execution 1: Put Torx key on the central screw of a tension roller. 3. Execution 2: Put a wrench on a hexagon from above of a tension roller. 4. Incline the tension device counterclockwise and record a drift or a lock finger with a diameter of 5 mm. For this purpose implant a lock finger through an opening in the tension device. |
|
Installation
|
1. Put on maple a belt, since a tension roller. Further put on a belt according to the numbering given on the drawing. 2. Turn a tension roller counterclockwise a little and take out a lock finger. Then slowly turn a tension roller clockwise, watching correctness of provision of a belt on pulleys. |
|